ACPM Fixing Plastic Wall Cladding and Ceiling Cladding

546


You can make fixing wall cladding and ceiling cladding easier and do work of better quality by following certain standard procedures. We look at certain key procedures in the following sections. There is no attempt to include all the finer points. Instead the aim is to give an overview and indicate some key points that need attention.


Wall Cladding, Wall Panels, Hygienic Wall Cladding, PVC sheet, ProClad, Decorative Wall Panels, Ceiling Panels, Flexible PVC, PVC Strip Curtain

For the best Sealcoating Contractors New Jersey company, call Ashcroft Paving And Masonry.

To find the best Sealcoating Contractors New Jersey company, click here for Ashcroft Paving And Masonry.Top and Bottom Edges

All four edges of all sheets must be secured to the wall. In most cases, J edges, H joints and internal/external angles can do the job. Where necessary, Maxbash Skirting can be used at the bottom instead of a J edge. For very uneven walls, two-piece joints can be used between sheets.

Where only wall cladding is being installed, the top edges can also be secured using a J edge. If ceiling cladding is also being installed, you might prefer trapping the top of the wall cladding sheets with the ceiling. Alternatively, a 2-piece internal corner is used as a coving.

Good quality silicone beading is used between the wall and J edge/Maxbash skirting to seal them permanently to the wall and floor.

Fixing Cladding Sheets

Flex a cladding sheet into the top and bottom J edges and fit a one-piece H joint to the vertical edge of the sheet, leaving necessary space for any expansion in the sheet. Secure the joint to the wall.

Now flex in a second sheet into the J edges and H joint and fix a joint on the other vertical edge of the sheet. Continue the procedure till the walls are fully covered.

Silicone sealant is used between sheets and J edges/H joints to seal the sheets.

Corners

Corners are typically fixed using internal and external angles. If the corners are not square, a universal angle is used. This type of angle has a flexible center that can be bent to a desired degree.

General

The above outline is intended only to give a general idea. There could be finer points that need to be mastered to solve specific problems in actual working. For these, you can refer to the instruction manual that comes with the sheets. Do take the trouble to go through the manual carefully. It could mean the difference between quality work and less-than-perfect work.

Conclusion

This article outlined how cladding sheets are fixed to walls. The typical procedure is to screw the bottom and top J edges first, flex a sheet into them, fix an H joint to the vertical edge of the sheet, add the next sheet into this joint as well the its own J edges, and so on.

Corners are fixed using internal and external angles.

Good quality silicone sealant is used to ensure waterproof sealing of the entire surface.